Failure Analysis and Component Testing of Plastics: Review of the DGM Training Course in Rheinbach
Why does a plastic component fail, and how can the cause be reliably determined? Participants in the DGM training course “Failure Analysis and Component Testing of Plastics” addressed these questions on 23 and 24 September 2026, in Rheinbach. The focus was on the properties of different groups of plastics, the influence of processing and aging, and mechanical, thermal, microscopic, and chemical testing methods. The small group of participants provided plenty of room to discuss specific damage cases and questions from professional practice.
Plastics are used in numerous technical applications, including highly stressed and safety-relevant components. When damage occurs, looking at the visible damage pattern alone is often not sufficient. Material selection, manufacturing, processing, environmental conditions, and aging can influence the behavior of a component and must be considered together when analyzing the cause.
This was precisely the starting point of the two-day training course led by Prof. Dr. Johannes Steinhaus from Bonn-Rhein-Sieg University of Applied Sciences.
From Material Behavior to Testing Strategy
At the beginning, the focus was on the fundamental properties of thermoplastics, thermosets, and elastomers. The different groups of plastics respond differently to mechanical, thermal, and chemical stresses. A sound understanding of the respective material behavior is therefore required for assessing damage.
Another key topic was the influence of processing. Manufacturing conditions can shape the later properties of components just as much as aging processes during use. For failure analysis, the question is therefore not only what can be observed on a component, but also which influences may have led to this condition.
Using Testing Methods in a Targeted Way
The seminar covered various methods for examining plastic components. These included mechanical and thermal testing methods as well as light and electron microscopy examinations. Chemical analysis methods, including spectroscopic and chromatographic techniques, were also addressed.
In connection with specific damage cases, participants discussed which methods are suitable for each question and how individual examination results can be combined into a reliable assessment. The selection of testing methods is itself an essential component of systematic failure analysis.
Room for Specific Questions
The small group of participants enabled an intensive exchange between participants and the training course leader. Personal experiences and questions from development, production, and quality assurance could be taken up and linked to the methods covered.
This practical relevance is particularly important in failure analysis: damage cases rarely follow a uniform pattern. The combination of materials knowledge, suitable testing technology, and a structured approach therefore forms the basis for narrowing down causes and assessing results in a professionally transparent way.
Training Course 2027
The next DGM training course “Failure Analysis and Component Testing of Plastics” will take place on 22 and 23 September 2027, in Rheinbach. The focus will once again be on the systematic investigation of damage cases, suitable methods of component testing, and the sound assessment of damage causes. Participants can also bring their own questions from professional practice into the discussion.